ニュース

さまざまなダストコレクションを扱う方法?

Hygroscopic deliquescent dust Hygroscopic and deliquescent dusts such as CaO, Na2CO3, NaHCO3, NaCl, 等. 水分を吸収しやすく、フィルターバッグの表面で固まりやすい, または潮解後に粘稠な液体になる. 掃除がしにくくなる原因になります, 圧力損失が大きい, and even force the dust collector to fail. When dealing with hygroscopic and deliquescent dust, the following should be...

パルスバッグダストコレクターの露の凝縮の分析と解を引き起こす

Analysis of Condensation Causes The condensation, refers to the phenomenon that saturated moisture is precipitated from moist air at a certain pressure and temperature. The temperature point at which moisture is released is called the dew point. The higher the gas pressure at saturation, the lower the dew point. The higher the moisture content in the air, the higher the dew point...

ダストコレクターの設置の正しいこと

パルス集塵機の日常使用上の注意 (1) 集塵機の設置が正常に動作している場合, the ash discharge cannot be stopped. Avoid dust accumulation in the hopper and force the dust collector to stop. Smoke and ash from the exhaust port indicate that the filter bag has been leaked. If any filter bag mouth is found to have dust...

集塵機の防爆設計のポイント

1 爆発の条件 1.1 pulverized coal temperature Different coal types have different ignition temperatures, ただし、より細かい石炭粉末の場合, due to the increased specific surface area, the explosion temperature is much lower than its ignition point. Usually the ignition temperature is below 40 . 1.2 Volatile matter of pulverized coal The combustible gas produced by the heating of pulverized coal is burned before...

セメント工場集塵の結露と処理方法

セメント工場の凝縮例の紹介 1 Example of high temperature type mill The cement mill with a diameter of 4.5m × 12.96m in a factory is a circular flow mill with a cyclone separator, and the end of the mill is dedusted by a flat-bag type dust collector. The mill system is indoors, the air convection between the mill and the...

工業用電気炉集塵機の設計と選定

工業用電気炉の分類: 抵抗炉, 誘導炉, 真空炉, 電子ビーム炉, 熱処理 (または製錬) ユニット, heat treatment auxiliary equipment, combustion furnace. Industrial electric furnace dust removal mainly uses bag filter, and the dust hood is designed according to different working conditions on site. したがって, the difficulty of industrial electric furnace dust removal lies in the design and arrangement of...